Historical records
would reveal that the sun's heat has been regarded to be the major source of man’s
everyday life not only during the earlier times but even in this present period
of time. This theory is indeed a real truth as individuals continue to make use
of the sun’s energy in countless ways.
With the
growth of Science and modern technology, there have been different inventions
that occurred. Among these was the introduction of Solar cells which is now a
great help towards our economic problems in thiscontemporary world. Right now,
using homemade solar panels to convert direct sunlight has motivated people to
become inquisitive about finding more strategies on how to build homemade solar cells.
It is important
that you should obtain the needed equipments like pre-wired Solar Series,
plywood, Masionite board, UV Shield, Anchoring screws, Plexiglas, Caulk as well
as a drill must you try to start with this endeavor.
Constructing
your homemade solar cells would just be easy and this is generated by
optimistically following the instructions given or by observing the video
lessons that are designed especially for those who really plan to pursue this
undertaking. You must remember though, that to bring out an effective and valuable solar
panel, you must set your mind and heart to it.
In so doing,
your first endeavor is to design a box just enough to store your entire solar
cells. shade it with 3 layers of UV Cover but be sure it’s properly covered
against UV rays of the sun. This is definitely vital as your pre-wired solar
cells will be placed here. Then bore holes at the back section of the solar
panel container so that high range of temperature can pass and thus, preventing the lumber from
perverting . You have to set inside of the wooden container a layer of Masonite
peg-board that's brushed with UV Shield for the solar panels to be fastened
there.When the solar panels are tightly attached to peg-board, it is required
to be contained in the solar panel box. The minute you have successfully done
with the wiring, you later cut the Plexiglas and tie it on top of the box. At
long last, you have now developed a solar panel.
No comments:
Post a Comment